![]() It is environmentally friendly, as it produces lesser noise and vibration compared to other drilling methods making it ideal for cities. The DTH method is the most productive and cost-effective method. Vibrations from the DTH percussive hammer can stimulate the formation to enhance production capability, reducing the need for hydraulic fracturing.DTH requires a minimal amount of rotational torque to cut rock that also allows the hammer to drill straight.Less wear and tear on the drill bit during drilling operation as the hammer is doing most of the work.Lesser time consumed compared to when the contractor has to be changed when geology changes.Rate of penetration of DTH is 2-5 times greater than the rotary drilling technique.Since cutting force is supplied by reciprocal force, the bit encounters lesser deflection and therefore drills more precisely.Less weight-on-bit allows for lighter rigs that are easier to set up and takedown.Less amount of drilling fluid and additives are required.The use of air makes this method very cost-effective as air does not have to be sourced, transported or treated.Lower operating costs, as the same drill will be used for drilling through dirt and rock.The DTH system is easily adaptable to most directional drills in a short period of time.Benefits of Down-The-Hole Drillingīelow are few of the many benefits associated with DTH drilling: It is then forced back out of the borehole along with the cuttings through the annular gap between the drill pipe and the borehole. The flushing medium (in some cases, water is also used) is pressed down through the drill pipes, down-the-hole hammer and the drill bit. compressed air is also the flushing medium. Since the piston strikes directly on the bit, energy transfer takes place down the hole with minimum loss of energy, allowing drilling to greater depths. This action along with the rotational movement of the drill string crushes the rock efficiently. The drill bit receives its striking power from a piston inside the hammer that is powered by compressed air. As the drill string rotates, the drilling hammer strikes down on the rock. It can be done on both hard and soft rock and is extensively used in the construction, oil and gas, and water well industries.ĭTH equipment consists of a drilling hammer and a piston-powered by compressed air. The DTH system is easy and quick to adapt to a directional drill and is considered one of the best and most effective methods to drill high-quality holes that are stable and straight. With DTH, it was now possible to turn 2-4 degrees curves and drill the well’s tangent up to 30 degrees or greater averaging 300 feet per hour, where rotary drilling would progress 30-40 feet per hour. ![]() The original estimate for completion of a 12,000-foot hole was 30 days using the conventional rotary technique, which was reduced to 13 days using the DTH method.īefore DTH was used, drillers would typically case the vertical portion of the well and convert to rotary drilling to drill at a tangent. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |